Bullard XS Serie Manual De Instrucciones página 2

INSTALLING THE CABLE IN THE CHARGER
MARKING AND DRILLING THE PANEL
Mark the locations of the five countersunk holes using the template
as a guide. Ensure that there are no sharp edges or burrs that could
harm the wiring insulation (Figure 3).
MOUNTING THE XS CHARGER
First, make sure that the power is disconnected from the supply
wiring. Next, connect the positive power source wire securely to the
red conductor located on the back of the XS Truckmount Charger. Then
connect the negative power source wire securely to the black con-
ductor located on the back of the XS Truckmount Charger.
The XS Truckmount Charger screws directly into the flat panel using
the five (5) #10 Hex Head Drilling Screws included in your installation
kit. Installation is now complete (Figure 4).
OPERATION
The XS Charger charging station is designed to perform the following
functions:
•Securing the imager and/or battery in the vehicle in accordance with
NFPA 1901-14.1.11.2 and EN1846-2.
•Storing and recharging the imager and/or battery and
maintaining the battery at full charge.
CHARGING CONFIGURATIONS
The XS Charger allows for a flexible camera management and can
charge simultaneously:
1) two imagers
2) two batteries
3) one imager and one battery
INSERTING THE TXS INTO THE XS CHARGER
NOTE
To store the TXS in the XS Charger, a battery must be
installed in the camera. Without a battery installed, the
rubber strap will not secure the camera properly. Therefore,
storing a camera without the battery installed can result in
non-compliance with NFPA 1901-14.1.11.2 and EN18462.
Set the imager firmly into place in the XS Charger. Maintain
the unit in position, fold over the rubber strap and attach in
place so that the rubber ball fits into the hook.
2
BULLARD XS CHARGER
INSTRUCTION MANUAL
Figure 3
Figure 4
Figure 5
w w w . b u l l a r d . c o m
1 2