Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
6.
Attach each of the remaining ends of the water supply lines (6.1) to
the hot and cold shut-off valves (6.2) and tighten with a wrench.
Do not overtighten.
7.
Once the installation is complete, remove the spray head (7.1)
from the spout (7.2) on the faucet body (A) to flush the water
lines. Turn on the water supply and allow both hot and cold water
to run for at least one minute to flush away any debris that could
cause damage to internal parts. While the water is running, check
for leaks. If a leak occurs, gently tighten the nut on the connection
that is leaking. Turn off the water and screw the spray head (7.1)
back onto the spout (7.2) of the faucet body (A).
NOTE: Do not lose the gaskets (7.3) in the hose.
8.
To install the optional soap dispenser, unscrew the top of the
soap dispenser (C) from the plastic soap bottle and remove the
mounting nut (8.1). From above the sink, insert the top of the
soap dispenser into the fourth hole opening in the sink. From
underneath the sink, thread the mounting nut (8.1) onto the
shank (8.1) to secure the soap dispenser (C) to the sink.
From underneath the sink, screw the plastic soap bottle (8.3)
onto the soap dispenser shank (8.2).
9.
To fill, lift the soap dispenser head and pump assembly (C) out
of the bottle (9.1) and pour no more than 8 oz. of liquid soap
(9.2 not included) into bottle (9.1). Reinsert soap dispenser
head and pump assembly (C).
5
6
6.1
6.2
7
7.2
7.3
7.1
8
2
C
2
8 .2
2
8 .1
2
8 .3
9
C
A
9.2
9.1
Publicidad
