Care And Cleaning - Project Source Kinsington 252-K825-PS-SSD 0865919 Manual De Instrucciones

OPERATING INSTRUCTIONS
The lever handles control the flow of hot and cold water to the faucet. Moving the handle forward opens
the cartridge and causes water to flow from the spout. Rotate the handle on the right side of the faucet
forward for cold water. Rotate the handle on the left side of the faucet forward for hot water. The degree of
handle opening determines the volume of water flow. Returning the handle to the original position away
from the spout on the faucet body stops the flow of water.

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
TROUBLESHOOTING
If a faucet installation doesn't deliver water properly or leaks, finding the cause and fixing it can be easy.
PROBLEM
Faucet leaks underneath
handle.
Water does not completely
shut off.
Faucet leaks around
aerator.
Faucet has an improper
water pattern.
POSSIBLE CAUSE
Bonnet has come loose or the
ceramic cartridge seal is dirty or
out of place.
Ceramic cartridge discs are worn
or have debris trapped inside.
The aerator is incorrectly fitted,
dirty, or small parts inside the
aerator are improperly installed.
The aerator is dirty or small parts
inside the aerator are improperly
installed.
SOLUTION
1. Move the handle to the OFF position. Unscrew the handle screw
and remove the handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge stem
to the ON position. The leak should stop draining out from around
the cartridge stem.
3. If the leak does not stop, shut off the water supply. Remove the
bonnet by turning it counterclockwise. Lift out the ceramic cartridge.
Inspect the seal on the bottom of the ceramic cartridge. Remove any
debris from the seal. If the ceramic cartridge seal is twisted or out of
place, re-seat it. If the ceramic cartridge seal is worn or damaged,
replace the cartridge by calling customer service.
4. Position the cartridge back into the faucet body. Make sure the
ridges on the two sides of the cartridge bonnet fit into the grooves on
the two sides of the faucet body. Tightly screw the bonnet onto the
faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unscrew the handle screw
and remove the handle.
3. Remove the bonnet. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the faucet body.
5. Tightly screw the bonnet into the faucet body.
6. Reinstall the handle.
1. Remove the aerator cover from the spout by turning it clockwise
and remove the aerator and gasket. Inspect the black rubber gasket
inside the aerator. The rubber gasket should be flat.
2. Reinstall the gasket and aerator, then replace and tighten the
aerator cover on the spout.
1. Remove the aerator cover from the spout by turning it clockwise and
remove the aerator and gasket.
2. Gently flush the small parts inside the aerator to clear away any
debris.
3. Reinstall the gasket and aerator, then replace and tighten the
aerator cover on the spout. Ensure all parts are straight and flat.
6