Emos E06018 Manual De Instrucciones página 4

6. Do not place the sensor onto metal objects as this will reduce
its transmission range.
7. If the low battery icon is displayed, replace batteries in the
sensor or weather station.
Switching Channel and Connecting Additional Sensors
1. Choose the desired channel 1, 2, or 3 for the sensor by
repeatedly pressing the
button; the
2. Unscrew the cover from the battery compartment on the rear
of the sensor and set the sensor switch to the desired sensor
channel number (1, 2, 3), then insert batteries (2× 1.5 V AAA).
Data from the sensor will be loaded within 3 minutes.
3. If sensor signal is not found, remove the batteries and proceed
again in accordance with steps 1 and 2 or press the TX button.
Upkeep and Maintenance
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and
moisture, and sudden changes in temperature as these may
compromise detection accuracy.
• Do not place the product in locations prone to vibration and
shocks; these may cause damage.
• Do not expose the product to excessive pressure,impacts,
dust, high temperatures or humidity – these may cause
malfunction, shorter battery life, damage to batteries and
deformation of plastic parts.
• Do not place any open flame sources on the product, e.g. a
lit candle, etc.
• Do not place the product in places with inadequate air flow.
• Do not tamper with the internal electric circuits of the product.
Doing so might damage it and automatically void the warranty.
• The product should only be repaired by a qualified professional.
• To clean the product, use a slightly moistened soft cloth. Do
not use solvents or cleaning agents; they could scratch the
plastic parts and cause corrosion of the electric circuits.
button. Then, long-press the
icon will start flashing.
4