2. USING ELECTRIC POWER
Make sure that the appliance is switched OFF before connecting it to the generator.
■ ■
Do not move the generator while it is running.
■ ■
Be sure to ground the generator if the connected appliance is grounded. Failure to
■ ■
ground unit may lead to electrical shock.
(1) CONTROL PANEL
GB
GB
GB
GB
GB
GB
GB
q MULTI MONITOR
GB
w AC RECEPTACLES
e GROUND TERMINAL
GB
GB
MULTI MONITOR
GB
q q LE display
GB
Operation hour, voltage and frequency are indicated in turns by
means of depressing the LE display changeover switch.
GB
In addition, "O_Lod" (overload) will be indicated when the generator
GB
is in the overload condition or appliance(s) will be out of order.
In this case, stop the engine immediately and check the appliance
GB
and/or generator for overloading.
GB
After the check and remedy, restarting the engine will resume
displaying in the normal manner.
w w Operation hour lamp
Lamp (red) is turned on when changing over into operation hour indication in the LE display.
e e Voltage lamp
Lamp (red) is turned on when changing over into voltage indication in the LE display.
r r Frequency lamp
Lamp (red) is turned on when changing over into frequency indication in the LE display.
t t LE display changeover switch
When depressing this switch, indication in LE display is changed over in turns;
operation hour → voltage → frequency → operation hour.
When starting the engine, operation hour is indicated in LE display at first.
y y Auto-power saving switch
When depressing this switch, auto-power saving function is activated.
u u Auto-power saving lamp
Lamp (green) is turned on while auto-power saving function is activated.
i i Engine oil level warning lamp
When the engine oil level is lower than the specified level, the lamp is turned on.
Then engine will be stopped.
8
WARNING
1
MULTI MONITOR
Hours
V
Hz
AUTO
P-SAVE
7
6
r DC TERMINALS
t DC CIRCUIT BREAKER
y KEY SWITCH [Electric starter model]
2
5
4
3
u ENGINE SWITCH
1
MULTI MONITOR
AUTO
P-SAVE
8
7
2
3
Hours
V
4
Hz
6
5