Dolmar GE-2800 IS Manual De Instrucciones página 15

NOTE
The following wattage chart is general guide only. Refer to your specific appliance for
correct wattage.
To determine the total wattage required to run a particular electrical appliance or tool, multiply the voltage
figure of the appliance/tool by the amperage (amps) figure of same. The voltage and amperage (amps)
information can be found on a name plate which is normally attached to electrical appliances and tools.
Applications
Incandescent lamp, Heater
Fluorescent lamp, Electric tool
Mercury lamp
Pump, Compressor
VOLTAGE DROP IN ELECTRIC EXTENSION CORDS
When a long electric extension cord is used to connect an appliance or tool to the generator, a certain
amount of voltage drop or loss occurs in the extension cord which reduces the effective voltage available for
the appliance or tool.
The chart below has been prepared to illustrate the approximate voltage loss when an extension cord of 100 meters
is used to connect an appliance or tool to the generator.
Nominal
Allowable
cross A.W.G.
section
mm No.
2
0.75 18
1.27 16
2.0 14
3.5 12 to 10
5.5 10 to 8
GE-2800 IS
2500
1300
800
500
No.of strands
Resistance
current / strands dia.
A No./mm
Ω/100m
7 30/0.18 2.477
12 50/0.16 1.486
17 37/0.26 0.952
23 45/0.32 0.517
35 70/0.32 0.332
Applicable Wattage (approx. W)
GE-3200 IS
50Hz
2800
1400
1000
600
Current Amp.
1A 3A 5A
2.5V 8V 12.5V ─
1.5V 5V 7.5V 12V 15V 18V
1V 3V 5V
─ 1.5V 2.5V 4V
1V 2V 2.5V 3.5V 4V
─
GE-4300 IS
3800
1900
1600
800
8A 10A 12A 15A
─ ─ ─
─
8V 10V 12V 15V
5V 6.5V 7.5V
5V
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
11