Maintenance; Daily Maintenance; Monthly Maintenance; Yearly Maintenance - Enerco H100 Instrucciones De Funcionamiento Y Manual Del Propietario

DISPOSAL OF ASHES
Whenever ash accumulates within the fire box or ash
pan to a height of 3-4 inches:
1. After ashes have cooled, remove ash plug and
carefully sweep ashes down into the ash bin.
2. Replace ash plug,remove ash bin, and empty into a
suitable container.
NOTE: You may also purchase a Ash Vacuum,
model# AV65GALB/AV65GALSS.
3. Ashes should be placed in a metal container with
a tight fitting lid and moved outdoors immediately.
The closed container of ashes should be placed
on a noncombustible floor or on the ground, well
away from all combustible materials, pending final
disposal. If the ashes are disposed of by burial in
soil or otherwise locally dispersed, they should be
retained in the closed container until all cinders have
thoroughly cooled.
4. Other waste shall not be placed in ash containers.

MAINTENANCE

DAILY MAINTENANCE

• Inspect the firebox for ash accumulation; remove
excess ash and follow instructions below regarding
disposal.

MONTHLY MAINTENANCE

• Check the blower for dust accumulation (if
installed); check the door handle for proper
operation and to be certain an airtight seal is still
being made by the door.
• Inspect the chimney system and chimney connector
and sweep if necessary. Although cleaning may be
required less than monthly, ALWAYS inspect the
venting system monthly to decrease the chance of
a chimney fire.
Wood Fire Stove
• Visually inspect the ceramic fiberboards in the
firebox for cracks and/or breakage. Slight surface
cracks will not affect the performance of the
boards, but cracked or crumbling boards should be
replaced immediately.
• Visually inspect the secondary combustion pipes
for cracks, warping and corrosion. Although
these tubes are constructed from stainless steel,
they operate at very high temperatures and can
eventually wear out from normal use.

YEARLY MAINTENANCE

• Check all gaskets (window and door) for wear and
to be certain they still maintain an airtight seal. See
the following page for instructions.
• Thoroughly clean the chimney system and the
chimney connector system. Since the chimney
connector is generally exposed to high exhaust
temperatures, inspect it carefully for leaks and
weak spots; replace any questionable pieces. In the
case of straight through the roof chimney system,
be certain to remove the ceramic fiberboards
before pushing the chimney sweeping brush down
into the firebox. Forcefully hitting the top of the
board with a cleaning brush or rod can damage or
destroy the boards.
• Remove all ash from the stove. Leave the air control
open during the non-heating months to allow
some air to flow through the stove to help prevent
corrosion.
WARNING: DO NOT ATTEMPT TO CLEAN
OR SERVICE WHILE THE STOVE IS HOT.
BEFORE OPENING THE STOVE DOOR FOR
ANY TYPE OF SERVICE, BE SURE THAT THE
STOVE IS COOL AND THAT THE BLOWER IS
UNPLUGGED.
WARNING: USE ONLY MANUFACTURER'S
REPLACEMENT PARTS. USE OF ANY OTHER
PARTS COULD CAUSE INJURY OR DEATH.
E19
Operating Instructions and Owner's Manual