Publicidad
Idiomas disponibles
Idiomas disponibles
GB
ASSEMBLY
Installing guide bar and saw chain
1).Loosen the fixing screw(9) and remove the chain cover(1).
Fig.2
2).Mount the guide bar then fit the saw chain around the bar and sprocket.
Fig.3
WARNING: PAY ATTENTION TO THE CORRECT DIRECTION OF THE SAW CHAIN.
3).install the chain cover ,and fasten the mounting nut finger tightness.
Fig.4
While holding up the tip of the bar, adjust the chain tension by turning the
tensioner screw(8) until the tie straps just touch the lower side of the guide bar.
29
Publicidad
