How To Change The Length Of The Contact Points; Testing Your E-Fence 3500 Prior To Installation - Dogtra Europe E-FENCE 3500 Manual De Instrucciones

HOW TO CHANGE THE LENGTH OF THE CONTACT
POINTS
The Dogtra E-Fence 3500 comes equipped with standard 15 mm contact points
that can be extended to 19 mm contact points, for use with dogs with longer
coats. To increase the contact point length from 15 mm to 19 mm, follow the steps
below.
1. Using the included adjustment tool with the side marked 5/8, unscrew the
contact points counter-clockwise.
2. Place the contact point extension over the exposed threads, flat side down.
3. Place the contact points over the extensions and tighten the contact points
and extensions clockwise using the adjustment tool with the side marked 3/4.
Caution : Tighten until firmly in place. Be careful not to over tighten.
To shorten the contact points back to the standard 5/8", start with the
adjustment tool with the side marked 3/4", remove the contact point extensions,
and tighten the contact points with the adjustment tool with the side marked
5/8".
46
TESTING YOUR DOGTRA E-FENCE 3500 PRIOR
TO INSTALLATION
2. Unwind the length of ground wire that was provided and strip about 1 cm off
each end. Insert both ends of the ground wire into the outer, red wire
connector jacks, leaving the center jack free. If the wires are connected
properly, the wire indicator light will be on.
3. Next, activate the receiver/collar by turning the intensity level dial on the
receiver to the desired level. The LED light will blink once every two seconds
showing that it is on.
* If not activated for 10 seconds or more, the system will go into sleep mode.
4. Hold the receiver in your hand with the contact points facing up. Place the test
lamp over the contact points and approach the test loop.
5. Watch for the test lamp to come on and the unit to vibrate. Be careful not to
touch the contact points as the unit will emit stimulation when activated.
1. To ensure that your E-Fence 3500 system
is working properly, connect the power
adaptor into the transmitter power jack
and then plug the power adaptor into a
household outlet. Switch the stimulation
knob to Pager + Stimulation, or Pager
Only. The On/Off indicator light should
turn on.
47