Wire Splicing - Dogtra Europe E-FENCE 3500 Manual De Instrucciones

IMPORTANT
Bury the fence wire after you have tested the system and are sure it is working
properly. Do not nick or scrape the fence wire during installation as it may result
in an intermittent signal or no signal. Make gradual turns at the corners with a
radius of at least 90 cm. This will provide a more consistent signal field that will
avoid confusing the dog in these areas.
DO NOT run the E-Fence boundary wire within 80 cm parallel to electrical,
telephone, cable TV or other buried wires.
DO NOT run the E-Fence boundary wire of one section within 10 feet of another
section of E-Fence wire or the signal may cancel.
DO NOT run the E-Fence boundary wire within 3 meters of a neighboring pet
containment system boundary wire.
Driveways/Sidewalks
When crossing an asphalt driveway, make a 1 cm deep cut across the driveway
using a circular saw and masonry blade. Close the crack with asphalt sealant
after the fence wire is placed in it. If an expansion joint is available on driveway
and sidewalks, place E-Fence wire in the joint and close it with outdoor caulk.
When crossing gravel, bury fence wire at least 7 cm deep. PVC pipes or a garden
hose can be used to protect the wire. In water, anchor the wire with large rocks.
Use PVC piping or garden hose to protect the wire.
54

WIRE SPLICING

The wire connection must be waterproof
center hole empty. A pair of pliers should be used to gently press down and snap
together the top of the blue part of the splice.
Loop goes around yard and connects
Loop
Incorrect
Twisted
wire
House
Transmitter
Incorrect Neutral Zone Wire
Splicing
Do not use electrical tape, or
soldered/twisted wire nuts in this
type of connection as it will cause an
intermittent signal or disarm the system.
The waterproof splices included in
he E-Fence 3500 system are designed
to provide a sealed connection between
the wires. The insulation on the
boundary wire should not be stripped
before placing wire into the holes.
To use the waterproof splices, boundary
wire is placed into the outer holes
of the splices. This should leave the
Boucle faisant le tour du terrain
20 cm
Loop
Correct
Twisted
wire
House
Transmitter
Correct Neutral Zone Wire
Splicing
55