Active AGi2100 Manual Del Usuario página 70

8. PERIODIC MAINTENANCE:
Air lter
3. Remove the foam element.
4. Wash the foam element in solvent and dry it.
5. Oil the foam element and squeeze out excess
of oil. The foam element should be wet but not
dripping.
NOTICE
Do not wring out the foam element when
squeezing it. This could cause it to tear.
6. Insert the foam element into the air filter case.
TIP:
Be sure the foam element seals properly against
the air filter holder to avoid air leakage.
The engine should never run without the foam element; excessive piston and
cylinder wear may result.
7. Install the air filter case cover in its original position and tighten the screw.
8. Install the cover and tighten the screws.
70
5
1. Remove the screws ①, and
then remove the cover ②.
2. Remove the screw ③ and then
remove the air filter case cover ④.
5