General Safety Information - Scheppach HC30o Traducción Del Manual De Instrucciones Original

Please observe that our equipment was not designed with
the intention of use for commercial or industrial purposes.
We assume no guarantee if the equipment is used in
commercial or industrial applications, or for equivalent
work.

5. General safety information

m WARNING! Read all safety information, instruc-
tions, illustrations and technical data for this electric
tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" used in the safety instructions
refers to mains-powered electrical tools (with a mains
cable) and battery-powered electrical tools (without a
mains cable).
Work area safety
Keep work area clean and well lit.
a.
Cluttered or dark areas invite accidents.
b. Do not operate power tools in explosive at-
mospheres, such as in the presence of flam-
mable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
c. Keep children and bystanders away while op-
erating a power tool.
Distractions can cause you to lose control.
Electrical safety
a. Power tool plugs must match the outlet.
Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
b. Avoid body contact with earthed or ground-
ed surfaces, such as pipes, radiators, ranges
and refrigerators. There is an increased risk
of electric shock if your body is earthed or
grounded.
c. Do not expose power tools to rain or wet con-
ditions.
Water entering a power tool will increase the risk
of electric shock.
d. Do not use the cable for another purpose, for
example, carrying or hanging the power tool or
pulling the plug out of the socket.
Keep the cable away from heat, oil, sharp edges
or moving device parts. Damaged or coiled cables
increase the risk of an electric shock.
If you work with a power tool outdoors, only
e.
use extension cables that are also suitable for
outdoor use.
Using an extension cable suitable for outdoor use
reduces the risk of an electric shock.
Only use approved and appropriately identified ex-
tension cables for use outdoors.
Only use cable reels in the unrolled state.
f. If operating a power tool in a damp location
is unavoidable, use a residual current circuit
breaker with a trigger current of 30 mA or less
to protect the power supply. Use of an RCD re-
duces the risk of electric shock.
Personal safety
a. Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
under the influence of drugs, alcohol or med-
ication.
A moment of carelessness when using electrical
tools can result in serious injuries.
Use personal protective equipment. Always
b.
wear eye protection.
Protective equipment such as a dust mask, non-
skid safety shoes, hard hat or hearing protection
used for appropriate conditions will reduce per-
sonal injuries.
c. Prevent unintentional starting. Ensure the
switch is in the off-position before connecting
to power source and/or battery pack, picking
up or carrying the tool.
Carrying power tools with your finger on the switch
or energising power tools that have the switch on
invites accidents.
d. Remove any adjusting key or wrench before
turning the power tool on.
A tool or spanner that is located in a rotating de-
vice part may result in injuries.
e. Do not overreach.
Keep proper footing and balance at all times. This
enables better control of the power tool in unex-
pected situations.
www.scheppach.com GB | 21