Fcc Requirements - Allen + Roth ARFPDF32F1 Manual Del Usuario

Ocultar thumbs Ver también para ARFPDF32F1:

Manual del usuario (40 páginas)

Contenido

Idiomas disponibles

Remote Wall Clip (see Fig. 33):

You can hang the remote on a wall using the provided clip. If

installing on a solid wood wall, drill 1/8" pilot holes and use the

provided screws. If installing on a plaster/wallboard wall, first

drill two 1/4" holes into the wall. Then, with a hammer, tap in the

two plastic wall anchors so that they are flush with the wall. Then

install the clip with the provided screws.

Battery Life:

Replace the batteries regularly. If the remote no longer functions

at a distance it previously did or the remote receiver does not

function at all, check the batteries. The receiver batters should

always provide a combined output voltage of at least 5.5 volts.

The hand-held remote should operate with as little as 2.5 volts of

battery power.

TROUBLESHOOTING

Any problems with the log set may be a result of the log set malfunctioning, or it may be due to the

remote system malfunctioning. First, review the manual to make sure all connections are properly made.

Then check the remote system in the following ways:

• Ensure the batteries are correctly placed in the receiver. If a battery is inserted incorrectly, the remote

system will not operate correctly.

• Check the battery in the remote to ensure the contacts are touching the positive (+) and

negative (-) ends of the battery. You can bend in the metal contacts for a tighter fit.

• Be sure the receiver and remote are within a 20 foot range of one another.

• Do not allow receiver to exceed 130°F. Battery life is shortened when exposed to temperatures above 115°F.

• Do not use rechargeable batteries—they do not supply enough power.

SPECIFICATIONS

Operating Frequency: 303.8 MHZ

FCC ID No.: Remote/Transmitter - 2ATZEFC20201 ; Receiver - 2ATZEFC20202

Remote/Transmitter Batteries: (2) 1.5V AAA

Receiver Batteries: (4) 6V AA 1.5 Alkaline batteries