Cameo P2 T Manual De Usuario página 13

3 FUSE
Fuse holder for 5 x 20 mm fuses. IMPORTANT: Replace the fuse only with a fuse of the same type
and value. In the event of repeated fuse failure, please contact an authorised service centre.
4 DMX IN
Male 5-pin XLR socket for connection to a DMX control device (e.g. DMX console).
5 DMX OUT
Female 5-pin XLR socket for sending the DMX control signal.
6 IDMX STICK
Connection for the optional iDMX stick for W-DMX™ connection (plug in the iDMX stick with the
antenna facing upwards).
7 OLED DISPLAY
The OLED display shows the currently activated mode (main display), the menu items in the menu
and the numerical value or operational status in certain menu items. If there is no input for around
two minutes, the display automatically returns to the main display. Note regarding the main
display in operating modes with external control: As soon as the control signal is interrupted, the
characters in the display begin to flash. When there is a control signal again, the flashing stops.
8 DIM / MENU
DIM – If one of the DMX modes is enabled and there is no DMX signal to the device, the encoder
serves as master dimmer control and you can set the brightness of the spotlight with values from
000 to 255 by turning the encoder (Quicklight).
MENU – Push the encoder to access the main menu and select menu items by turning the encod-
er. Press the encoder to enter a submenu, change values and status by turning the encoder and
confirm the changes by pressing the encoder.
13