Cameo P2 T Manual De Usuario página 16

SLAVE MODE
Press the encoder to access the main menu. Rotate the encoder to select the menu item Slave
(observe left selection arrow) and confirm by pushing the encoder. Slave mode is now enabled,
and the main display is automatically displayed. Connect the slave and master unit (same model,
same software version) using a DMX cable, and activate stand alone mode on the master unit. The
slave unit will now follow the master unit.
Menu
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
DEVICE SETTINGS (Settings)
Press the encoder to access the main menu. Rotate the encoder to select the menu item Set-
tings (observe left selection arrow) and confirm by pushing the encoder. This will take you to the
submenu for setting the submenu items (see table, rotate the encoder to select, push the encoder
to confirm selection). Now select the arrow symbol for "back" at the top of the submenu. Push the
encoder and access the main menu in the same way to return to the main display.
Menu
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
Settings
Back
Wireless = Configure wireless
Settings control (IDMX stick
optionally available)
16
Mode
Slave
Back
WDMX
State
On
Off
Signal
routing
Receive only W-DMX reception only
To XLR
Backup by
XLR
Back
Wireless control enabled
Wireless control disabled
Back
Signal -> DMX OUT
Backup via DMX IN with W-DMX
signal interruption