Steelcase Migration SE Instrucciones De Uso página 47

Signal/Code
Flashing green
6.3.2 Table of error messages with the Memory
control panel
Signal/Code
HOT
ISP
CON followed by ERR
For other error messages, please have a look in the detailed user guide on
steelcase.com/eu-en
ERR followed by ERROR
NUMBER
Message Required measure(s)
System starts up To carry out any subsequent
steps, wait until the LED is
The system is being
no longer flashing. Do not
reset
press any buttons!
Duty cycle exceeded
Collision detected Remove the obstacle from
(ISP) the table system. Remove
any unnecessary loads from
the desktop. The DM system
can be used as usual .
Message
The overheating
protection circuit has
been activated.
The system has
detected a collision.
The system has
detected a
connection error.
An internal error has
occurred.
6 Errors and faults
Required measure(s)
Wait until the overheated
components have cooled
down.
Release all buttons and wait
until the drive back function
process is completed.
Release all buttons and wait
5 seconds. Then try again.
Disconnect the power
supply from the mains
connection. Then
disconnect the system from
the power supply. Re-
connect the system and use
it as usual.
Read the table below to
determine the correct
corrective measure for the
indicated error code.
EN
47