Operating The Tester; Safety Instructions - Beha-Amprobe 2100-Alpha Manual Del Usuario

The voltage tester 2100-Beta offers dual display for
voltage test – LED and LC display.
• Voltage Test
- Display by LEDs 12...690 V AC/DC
- Display by LC display 12...690 V AC/ DC (2100-Beta
only)
• Automatic AC/DC voltage detection, indication of
polarity
• Audio indication when detected voltages above 50
VAC and 120 VDC
• Two pole phase rotation indication – no third hand
required
• Data Hold (HOLD) (2100-Beta only)
• Switchable load of 240 W with two push buttons
• Trip of RCD (30mA) by push buttons
• Single pole test for phase indication
• Continuity test with visual (LED) and audio indication
• Torch light for dark environment
• GS approved, built according to EN 61234-3:2010
• Safety rated CAT IV 600 V, CAT III 690 V
• IP 64 splash-proof and dust-tight
• Protective probe caps for reducing the risk of injury
• Quick single hand test on mains socket with 19 mm
contact distance

OPERATING THE TESTER

Safety Instructions

The voltage testers have been constructed and tested in
accordance with the safety regulations for voltage testers
and have left the factory. To prevent injuries and damages
to the Voltage Tester, follow the safety instuctions in this
manual.
Read Before Using:
W
Danger of electric shock
• To avoid an electric shock, observe the precautions
when working with voltages exceeding 120 V (60 V)
DC or 50 V (25 V) r.m.s. AC. In accordance with DIN
VDE these values represent the threshold contact
voltages (values in brackets refer to limited ranges,
e.g. in agricultural areas).
• The acoustic indication ≥50 V AC and ≥120 V DC is only
to warn the user, not for measuring.
• Before using the Voltage Tester at locations with a
high background noise level, it should be determined
whether the audio signal is perceptible.
• The Voltage Tester shall not be used with the battery
compartment open.
• Before using the Voltage Tester, ensure that the test
lead and test Voltage Tester are in perfect working
condition. Look out e.g. for broken cables or leaking
batteries (if applicable).
• The batteries shall be checked before use and be
replaced if necessary.
• Hold the Voltage Tester and accessories by the
designated probe handles only, the display and
indicating LED must not be covered. Do not touch the
test probes before and during test.
• The Voltage Tester may be used only within the
specified measurement ranges and in low-voltage
installations up to 690V.
• The test Voltage Tester may be used only in the
measuring circuit category it has been designed for!
• Before and after use, always check that the Voltage
Tester is in perfect working condition (e.g. check on a
known voltage source).
• The functioning of the Voltage Tester shall be checked
shortly before and after a test. If indication of one or
more steps fails, or no functioning is indicated, the
Voltage Tester shall no longer be used.
• The Voltage Tester complies with protection class IP 64
(splash-proof and dust-tight) and therefore can also
be used under humid conditions.
4