Publicidad
Idiomas disponibles
Idiomas disponibles
!
Warnings not to use the infant carrier in the area of airbag deploy-
ment.
!
Note that Rearward facing infant carrier should only be installed on
forward facing passenger seats.
How to install the baby seat using the aircraft seat's safety belt:
1. Place the infant carrier opposite to the flight direction onto the
passenger seat.
2. Ensure that the carry handle is in the topmost position.
3. Place the safety belt into both light green belt guides.
4. Close the safety belt (refer to the safety instructions by the airline).
5. Tighten the safety belt by pulling the belt end.
!
The buckle of the safety belt must under no circumstances lie within
the light green belt guides.
Removal:
Open the safety belt of the passenger seat (refer to the safety instruc-
tions by the airline).
Now you can take the baby seat from the passenger seat.
Handle Adjustment
1
2
3
11
2
1
The handle of the infant carrier module can be adjusted to 3 positions.
!
Position for car, hand or stroller transportation.
To adjust the handle, squeeze the handle buttons on both sides to
release it, and then rotate the handle until it clicks into any of the 3
positions.
Installation with base
see images
-
1
13
1. Attach the ISOFIX guides to the vehicle's ISOFIX anchor points (see
vehicle owner's manual).
1
surface of the vehicle seat from being torn. They can also guide the
ISOFIX connectors.
2. Unfold the load leg from storage compartment.
3. Extend the ISOFIX connectors by pressing the ISOFIX adjustment
button while pulling on the connector.
4. Press the ISOFIX adjustment button to adjust the ISOFIX
connectors. Line up the ISOFIX connectors with the ISOFIX guides,
and then click both ISOFIX connectors into the ISOFIX anchor
points.
4
!
Make sure that both ISOFIX connectors are securely attached to the
vehicle's ISOFIX anchor points. There should be two audible clicks
and the colors of the indicators on both ISOFIX connectors should
be completely green.
-1
4
!
Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor
. When the load leg is installed correctly, the load leg
5
indicator will show green. Red will be shown when installed
incorrectly.
-2
5
The load leg has multiple positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
The ISOFIX guides can protect the
2
3
12
Publicidad
