TROUBLESHOOTING
PROBLEM
CAUSE
◾
The battery pack is not attached
to the trimmer.
◾
No electrical contact between
the trimmer and battery.
◾
The battery pack is depleted.
Line trimmer fails to
◾
start.
The lock off switch is not
being moved forward before
depressing the variable speed
trigger.
◾
The motor shaft or trimmer head
is bound with grass.
◾
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
◾
Heavy cutting line is used.
Line trimmer stops
while cutting.
◾
The battery pack or line trimmer
is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
◾
The motor shaft or trimmer head
is bound with grass.
◾
There is not enough line on the
spool or the line breaks from
the eyelet.
◾
The line is tangled.
Trimmer head will not
advance line.
◾
The line is too short.
◾
Heavy cutting line is used.
◾
Trimmer head malfunction.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1610E-T
SOLUTION
◾
Attach the battery pack to the trimmer.
◾
Remove battery, check contacts and reinstall
the battery pack.
◾
Charge the battery pack.
◾
Move the locking tongue forward and then
press the variable speed trigger.
◾
Remove the grass from the motor shaft and
trimmer head.
◾
Remove the battery pack and mount the guard
on the trimmer.
◾
Use recommended nylon cutting line with
diameter 2.4 mm.
◾
Cool the battery or line trimmer.
◾
Re-install the battery pack.
◾
Charge the battery pack.
◾
Stop the trimmer, remove the battery, and clean
the motor shaft and trimmer head.
◾
Remove the battery and replace the cutting line
following "LINE REPLACEMENT" section in
this manual.
◾
Remove the battery; remove the line from
the trimmer head and rewind following
"RELOADING THE CUTTING LINE" section in
this manual.
◾
Remove the battery and pull the lines manually
while alternately pressing down and releasing
the trimmer head.
◾
Use recommended nylon cutting line with
diameter 2.4 mm.
◾
Call EGO Customer Service for help.
EN
13