EGO ST1610E-T Manual De Instrucciones página 14

EN
PROBLEM
Trimmer head con-
tinues to release line
automatically.
Grass is wrapped
around trimmer head
and motor housing.
The blade is not cutting
the line.
Cracks on the trimmer
head
The cutting line cannot
be wound into the trim-
mer head properly.
The cutting line cannot
be passed through the
trimmer head when
inserting the line.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
14
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1610E-T
CAUSE
◾
Light cutting line is used.
◾
Cutting tall grass at ground level
◾
The line-cutting blade on the
edge of the guard has become
dull.
◾
The trimmer head is worn out.
◾
Improper cutting line is used.
◾
Grass debris or dirt has
accumulated in the trimmer
head and blocked the movement
of line spool.
◾
Motor is overheated due to
repeatedly operating the line
winding system.
◾
Low battery capacity
◾
The line is not wound into the
spool assembly.
◾
Trimmer head is defective.
◾
The cutting line is split or bent
at the end.
SOLUTION
◾
Use recommended nylon cutting line with
diameter 2.4 mm.
◾
Cut tall grass from the top down, removing
no more than 20 cm in each pass to prevent
wrapping.
◾
Follow instructions to sharpen the line-cutting
blade with a file or replace it with a new blade.
◾
Replace the trimmer head immediately
following "TRIMMER HEAD REPLACEMENT" in
this manual.
◾
We suggest that you use EGO original nylon
cutting line. If using EGO nylon line and the
problem persists, please call EGO customer
service for advice.
◾
Remove the battery, open the trimmer head and
clean it thoroughly.
◾
Let the line trimmer work under no load for
a few minutes to cool the motor, then try to
reload the line.
◾
Charge the battery
◾
Pull out the line and reinsert it.
◾
Call EGO Customer Service for help.
◾
Cut the worn end of line and reinsert.