EGO ST1610E-T Manual De Instrucciones página 8

SPECIFICATIONS
EN
Voltage
No-Load Speed
Cutting Line Mechanism
Cutting Line Type
Cutting Width
Recommended Operating
Temperature
Storage Temperature
Weight (without battery pack) 3.5 kg
Measured sound power level
L
WA
Sound pressure level at
operator's ear L
PA
Guaranteed sound power level
L (measured according to
WA
2000/14/EC)
Front
Valuation of handle
vibration a
Rear handle
h
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE: The vibration emission during actual use of the
power tool can differ from the declared value in which
the tool is used; In order to protect the operator, user
should wear gloves and ear protectors in the actual
conditions of use.
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Variable Speed Trigger
2. Rear Handle
3. Locking Tongue
4. 2-Speed Switch
5. Speed Indicator
8
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1610E-T
6. Height Locking Collar
7. Quick Adjustable Front Handle
8. Quick-release Lever
56 V
Low speed range:
9. Hinge & Locking Bolt
3500-4800 min
-1
10. POWERLOAD
High speed range:
4000-5500 min
-1 11. Trimmer Head (with LINE-IQ Feeding)
LINE-IQ FEEDING
12. Cutting Line
2.4 mm nylon twist line
13. Release Tab
40 cm
14. Line-Cutting Blade
0°C - 40°C
15. Guard
16. Ejection Mechanism
-20°C - 70°C
17. Latch
18. Battery Release Button
90 dB(A)
19. Hex Wrench
K=2 dB(A)
20. Shoulder Strap Loop
77 dB(A)
21. Shoulder Strap
K=3 dB(A)
PACKING LIST (FIG. A1)
92 dB(A)
ASSEMBLY
3,89 m/s
2
K=1.5 m/s 2
UNFOLDING THE SHAFT
2,7 m/s
2
K=1.5 m/s
2
or fingers, do not hold the shaft at the joint.
until the shaft has been locked.
Unfold the shaft gently, ensuring the cable inside the
shaft and lock it with the bolt by the supplied wrench
(Fig. B1 & B2).
MOUNTING THE GUARD
or replacing the guard. Be careful of the blade on the
guard and protect your hands from being injured by
the blade.
Position your trimmer so that the trimmer head faces
up (Fig. C1). Align the guard mounting holes with the
assembly holes and then lock the guard on the shaft
base with the two screws (Fig. C2).
NOTICE:
C1 & C2, any reverse fixing will cause great danger!
Button
TM
WARNING: In order to avoid pinching your hands
WARNING: Do not attempt to start the trimmer
WARNING: Always wear gloves when mounting
Make sure the guard is fixed according to Fig.