Publicidad
Idiomas disponibles
Idiomas disponibles
the right: increase torque. Loosen to the left: decrease torque.
6. Air motor will automatically stop when the load reaches at the pre-set torque.
7. Refer to our Air-inlet changed manual to convert into different air-inlet.
1. Air tools are adversely affected by moisture. Since air from compressor contains much
moisture and dust, it is desirable to provide a filter and lubricator in the pipeline to remove
such undesirable elements. Also take the drain out from air tank every day.
2. When using brand-new air hose or air pipe. Blow and clean the inside of air hose or pipe
before installation.
3. Keep inside of air hose or air pipe clean to prevent airdrop problem caused by the lots of
drain and dust accumulated and possibly make the inside diameter smaller in the long use.
4. When disconnect air hose from air tool while in the operation do not drop air hose end to the
floor as dust or other element may come into air hose.
5. Use air regulator to keep stable air pressure at 5.5kg/cm²-6.0kg/cm² at the toll. It is important
to get proper air pressure at the toll.
6. After lubrication, oil will discharged the exhaust upon operation. Flush motor for a few
seconds.
1. Lubrication is indispensable to air tolls. The most ideal maintenance is to install one lubricator
to a toll for automatic oil feed, but if it is not available, manual lubrication twice every day is
recommended for longer life and keeping the efficient function of mechanism.
2. For manual lubrication, disconnect air hose from bushing air inlet and full up spindle oil (#40-
#60) into the air feed in take and push the bit.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the device
being incorrectly used or, applied for a purpose for whith it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the device owner 12 months against any manufacture defect.
This guarantee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
AIR SUPPLY
LUBRICATION
NOTES
GUARANTEE
5
Publicidad
