2-DECLARATION OF CONFORMITY - USA
USA - FCC requirements
- FCC ID: O9BARVAADV4
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep-
tion which can be determined by turning the equipment off and on, the user is encouraged to try to correct interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation. This device complies with FCC radiation exposure limits set forth for general population.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Manufacturer / Fabricant :
ARVA NIC-IMPEX
8 RUE DES BOUVIÈRES
74940 ANNECY-LE-VIEUX
FRANCE
Tél : +33(0) 450 571 351
www.arvaequipment.com
ARVA US Service Center
399 W. 1200 N.
SUITE A
Orem, UT 84057
Tel : +1 (844) 636-2782
75