VONROC EH513AC Traducción Del Manual Original página 5

H. Timer indicator
11. Temperature lower button
12. Temperature higher button
13. On / off button
14. Mode button
15. Oscillation button
16. Timer button
17. Power cable
3. OPERATING
Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface.
• Keep a minimum distance of 1 m between the
front of the housing and walls, combustible
materials (furniture, curtains, etc.) and 30 cm
from all other housing surface areas. Keep away
from wet environments.
Warning! Make sure to place the heater in
a safe spot, so you cannot easily trip over
the machine and cable. Make sure to place
the heater where it cannot fall down / of.
Starting the electric heater (Fig. A, B)
• Plug in the cable (17) to the mains.
• Turn the main switch (7) on.
• The power indicator light (10A) will light up.
• Press the on/off button (13). The temperature
LCD-display (9) will show the default tempera-
ture 25 C).
o
Adjusting the temperature
• Set the temperature as desired by using the
temperature buttons (11,12). The temperature
can be set between 15
• The heater will automatically select a mode
depending on the set temperature and room
temperature. Press the mode button (14) to
change the heating mode.
WWW.VONROC.COM
C and 35 C.
o o
• Low heating mode – 1200W: the low heating
indicator (10C) and the temperature indica-
tor (10D) will light up.
• High heating mode – 1800W: the high
heating indicator (10B) and the temperature
indicator (10D) will light up.
• Fan: The temperature indicator and the
LED-display will turn of. The fan indicator
(10F) will light up.
Constant room temperature
The heater starts and stops automatically to keep
the room temperature constant. Once the ambient
temperature in the room reaches the desired target
temperature, the heating element will be in standby
mode. Once the ambient temperature starts to
decrease, the heating element will be switched on
again.
Timer button (Fig. B)
The timer can be set between 1 hour and 9 hours.
The display will show the duration currently set.
Press the timer button (16) to set the timer with 1
hour intervals. The timer indicator (10H) will light
up. Without a timer there is no limit.
Oscillation button (Fig. B)
Press the oscillation button (15) to activate the
heater to swing. The oscillate indicator (10G) will
light up. Press it again to deactivate.
Tip-over switch (5) (Fig. A)
This heater has an mechanical tip-over protection.
This protection ensures when the heater is not
placed upright on a firm and level surface or when
the heater tip over, the system will automatically
shut the heater off. If this occurs, put the heater on
a firm and level surface and start the heater again.
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
If this occurs, the heater can only resume after
resetting it. To reset the heater: Unplug the heater
and wait at least 30 minutes to cool down before
restarting the heater.
EN
5