VONROC MS505AC Traducción Del Manual Original página 8

EN
2. MACHINE INFORMATION
Intended use
The electro tool is intended as a stationary machine
for making straight lengthways and crossways cuts
in wood. Horizontal mitre angles of -45° to +45° as
well as vertical bevel angles of -45° are possible.
This saw is intended for sawing wood only.
Do not use the saw to cut materials other
than wood.
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Capacity
Machine class
No load speed
Saw blade measurement
Angle for mitring
Angle for bevelling
Mitre saw maximum sawing
capacity:
Mitre 0° - Bevel 0°
Mitre 0° - Bevel 45°
Mitre 45° - Bevel 0°
Mitre 45° - Bevel 45°
Weight
Lpa (sound pressure)
Lwa (acoustic capacity)
The declared noise emission value(s) have been
measured in accordance with a standard test
method and may be used for comparing one tool
with another. The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure. The noise emissions during actual use of
the power tool can differ from the declared values
depending on the ways in which the tool is used
especially what kind of workpiece is processed.
Need to identify safety measures to protect the op-
erator that are based on an estimation of exposure
in the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time).
8
MS505AC
220-240V~, 50Hz
1500W
II (double insulated)
4.500/min
216 x 30 x 2.8mm
45° (left and right)
45° (only left)
70 x 305mm
35 x 305mm
70 x 210mm
35 x 210mm
12 kg
93.6+3 dB(A)
106.6+3 dB(A)
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/off switch
2. On/off switch for laser
3. Lock-off button
4. Carbon brush cover
5. Lock-pin
6. Blade protective cover
7. Workpiece clamp
8. Guide fence
9. Knob adjusting saw angle
10. Locking knob
11. Locking paddle
12. Knob over sliding support
13. Connection dust bag
14. Bevel angle
16. Cover
17. Saw blade bolt
18. Flange
19. Screw
20. Screw retraction arm
21. Extension pieces (left and right)
22. Lock-button saw blade
23. Angle indicator
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
Install of a stationary machine (Fig. F)
This machine is a stationary machine and for safety
reasons must always be firmly installed and not
used for mobile applications.
You can install the machine in two ways:
a) As a stationary machine on a workbench.
In case the machine must be secured to the
workbench with 4 bolts.
b) As a stationary machine on a sub frame. In this
case the machine must be secured to the sub
frame with 4 bolts and the sub frame anchored
with 4 bolts to the floor plate with dimensions
of at least 1 square meter.
Installation of the mitre saw (Fig. B)
• Place one sidebar (21) on the right-hand side of
the machine and the other sidebar on the left-
hand side of the machine.
WWW.VONROC.COM