Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL BUTTON:
GAS CONTROL：
1.LIGHTING INSTRUCTION
A.The heater has three settings. Lighting position（Pos.1）Minimum position (Pos.2) ;
Medium position (Pos.3) Maximum position (Pos.4).
B.Turn on the gas on the container.
2. LIGHTING:
Use one hand Press down the control button for 10 seconds, at the same time press down
the piezo igniter key with thumb finger of another hand. Continue this procedure until pilot is
ignited. Approximately 20 seconds later release the control button. At the moment if pilot is
ignited, it means that the heater is at its minimum position. If pilot flame goes out, please
repeat this procedure.
3. HEAT LEVEL SETTINGS
To change from minimum to medium. Please gently press down the control button and turn
it to position 2.
To change from medium to maximum. Please gently press down the control button and turn
it to position 3.
4. SWITCHING OFF
Turn off the gas on the container. If the heater will not be used for a period of time, please
disconnect the regulator from the container and replace any valve protection plug or cover. If
the heater fails to extinguish, please do not disconnect the regulator from the container and
remove the heater outdoors and let the gas in the container used up.
WARNING
1.
Read these instructions before using this appliance.
2.
The appliance is not to be used by children or persons with reduced physical,sensory or
mental capabilities,or lack of experience and knownledge,unless they have been given
supervision or instruction.
3.
Children being supervised not to play with the appliance.
4.
Do not used the heater with a programmer,timer or any other device that switches the heater
on automatically.
5.
Use an approved regulator which is adjusted to the gas supply pressure required.
6.
Do not keep pressing the ignition button for more than 40 seconds.
7.
Never disconnect the regulator while container valve is open.
8.
Don't change container with in areas in which open fire exists.
5
Publicidad
