Profi Care PC-HSM/R 3051 Manual De Instrucciones página 16

3. Plug the power supply unit into wall outlet.
4. Charge the appliance before first use for 9 hours.
• The indicator light remains red during the charging process.
• The charge indicator does not indicate the state of charge of the rechargeable
battery.
• If the rechargeable battery is empty, the appliance can be operated via mains
power. In order to do so, connect the power supply unit directly to the appliance.
The indicator lamp lights up orange during mains operation.
5. After initial use, do not charge the battery for longer than 9 hours at one time.
• After 9 hours always disconnect from mains power supply.
You will extend the life of the rechargeable battery if you observe the following:
• Wait until the rechargeable battery is almost empty before charging.
• Do not leave the appliance connected to the charger for more than 14 hours.
• Only charge the appliance at an ambient temperature between 0 °C and + 40 °C.
Switching On and Off
Slide the switch (1) to turn the appliance on or off.
Adjust Cutting Length
1. Turn off the appliance. OFF can be seen on the switch.
2. Attach the shaving head to the appliance as described under "Cleaning".
3. Select a comb attachment. Each comb is marked with its cutting length.
4. Attach the desired comb: Also refer to figure
the shaving head into the jags of the comb. Firmly push the comb onto the clipper
head until it locks into place.
5. In order to remove the comb attachment, push the locking catch out of its lock.
Cut Hair and Beard
1. Select the cutting length.
2. Switch the appliance on. ON can be seen on the switch (1) and the indicator lamp
lights up green.
16
PC-HSMR3051_IM_new2
Using the Appliance
on page 3. Slide the blades of
27.12.22