Coolant - Benelli TRK 251 Manual Del Propietário

Coolant

The coolant level should be checked befo-
re each ride. In addition, the coolant must
be changed at the intervals specified in
the periodic maintenance and lubrication
chart.
To check the coolant level
1. Place the vehicle on a flat surface and
keep it upright.
TIP
• The coolant level must be checked
on a cold engine since the level va-
ries with engine temperature.
• Make sure that the vehicle is positio-
ned straight up when checking the
coolant level. A slight tilt to the side
can result in a false reading.
2. Check the coolant level in the coolant
reservoir.
USOeMANUTENZIONE_TRK251_2019.indb 13
TIP
The coolant should be between the mini-
mum and maximum level marks.
1
2
1. Coolant reservoir
2. Coolant reservoir cap
3. If the coolant is at or below the mini-
mum level mark, remove the coolant re-
servoir cap.
6 - 13
Periodic maintenance and adjustment
WARNING
Remove only the coolant reservoir cap.
Never attempt to remove the radiator
cap when the engine is hot.
4. Add coolant or distilled water to raise
the coolant to the maximum level mark,
install the coolant reservoir cap.
NOTICE
If coolant is not available, use distilled
water or soft tap water instead. Do not
use hard water or salt water since it is
harmful to the engine.
If water has been used instead of coo-
lant, replace it with coolant as soon as
possible, otherwise the cooling system
will not be protected against frost and
corrosion. If water has been added to
the coolant, have a Benelli dealer check
the antifreeze content of the coolant as
soon as possible, otherwise the effecti-
veness of the coolant will be reduced.
EN
6
27/02/2019 12:09:22