Publicidad
Idiomas disponibles
Idiomas disponibles
Receiver operations (only BASIC-PLUS and BASIC+MN versions)
Upon receiving a code, the equipment checks whether it is in its memory, activating the corresponding relay.
Manual programming
1) Normal programming
Press the RADIO PROG programming button for 1 sec. The programming RADIO PROG pilot light will come on and the
equipment will emit an acoustic signal. The equipment will enter normal programming. Send the code and the channel to be
programmed by pressing the transmitter.
Every time a transmitter is programmed, the equipment will issue an acoustic signal for 0.5 sec. After 10 seconds without pro-
gramming or by pressing the programming button, the equipment will exit programming mode, issuing two 1 sec. acoustic sig-
nals. If, on programming a transmitter, the equipment memory is full, it will issue seven 0.5 sec. acoustic signals and exit
programming.
By pressing the transmitter channel, opening and closure is activated in automatic operating mode.
2) Programming for pedestrian function
In normal programming, press the RADIO PROG programming button again and keep it pressed down until the RADIO
PROG pilot light flashes and the equipment emits a short acoustic signal. The equipment will now have entered programming
for pedestrian function. Press the required channel of the transmitter to be programmed.
The first channel opens and the second closes (3rd channel opens and 4th channel closes).
Every time a transmitter is programmed, the equipment will issue an acoustic signal for 0.5 sec. After 10 seconds without pro-
gramming or by pressing the programming button, the equipment will exit programming mode, issuing two 1 sec. acoustic sig-
nals. If, on programming a transmitter, the equipment memory is full, it will issue seven 0.5 sec. acoustic signals and exit
programming.
N.B.: Each transmitter channel can be configured independently on the equipment, occupying only one memory position.
Programming by radio
To enter programming, press the first two buttons on a transmitter that has already been registered on the equipment.
The equipment will issue a 1 sec. acoustic signal. On pressing any button on the new transmitter, the equipment will issue
another 1 sec. acoustic signal to indicate that it has been memorised. The new transmitter will maintain the same channel
configuration as the transmitter registered.
After 10 seconds without programming or by quickly pressing the programming button or pressing the first two transmitter but-
tons, the equipment will exit programming mode, issuing two 1 sec. acoustic signals.
Code cancellation (total reset)
In programming mode, the programming button is held down and the "MR" reset jumper is bridged for 3 secs. The equipment
will issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation has been suc-
cessful. The equipment is now in programming mode. The pilot programming light will also follow the acoustic indications by
flashing.
After 10 seconds without programming or quickly pressing the programming button, the equipment will exit programming
mode, issuing two 1 sec. acoustic signals.
Optional cards
Receiver card
This acts on the panel with transmitters, proximity keys or smart cards in the same way as the start button.
jcmtechnologies
8
Publicidad
