jcm-tech BASIC-PLUS Manual De Instrucciones página 9

Use of the equipment
This equipment is designed to automate garage doors following the general description. It is not guaranteed for other uses.
The manufacturer reserves the right to modify equipment specifications without prior notice.
Important safety instructions for installation
•Before installing the panel, remove all unnecessary ropes or chains and disable any equipment such as locks that is
not necessary for the automatic operation.
•Before installing the panel, check that the door is in good mechanical condition, correctly balanced and that it opens
and closes correctly.
•Install the manual unlocking device at a height lower than 1.8m.
•Install any permanent control next to the door away from any moving part and at a minimum height of 1.5m.
•An easily accessible disconnection device must be fitted to the wiring for permanently connected equipment. It is wise
for this to be an emergency switch.
•For correct use of the security edge, this must never be activated when the door is fully closed. It is wise to install the
ends of run before activating the edge.
•This equipment can only be handled by a specialist fitter, by maintenance staff or by a suitably trained operator.
•To connect the power supply and motor wiring, 1,7 mm2 section terminals must be used.
•Fuses must only be handled when the appliance is disconnected from the mains.
•The instructions for using this equipment must remain in the possession of the user.
•European door normative EN 12453 and EN 12445 specify the following minimum protection and door safety levels:
- for single-family homes, prevent the door being able to come into contact with any object or limit the contact force
(e.g. security edge) and, in the event of automatic closure, a presence detector (e.g. photocell) must be added.
- for communal and public installations, prevent the door being able to come into contact with any object or limit the con-
tact force (e.g. security edge) and detect presence (e.g. photocell).
Important safety instructions for use
•Do not allow children to play with the door controls.
•Keep the remote controls out of the reach of children.
•Watch the door movement and keep people away until the door is fully open or closed.
•Precaution when operating the manual unlocking device, as the door may suddenly fall due to the bad condition of the
springs or door unbalance. Details on how to use the manual unlocking device must be provided by the manufacturer
or the device installer.
•Examine the installation frequently, especially the cables, springs and supports, to detect signs of wear, damage or
unbalance. Do not use the door if repair work or adjustments are required, as this may cause damage.
jcmtechnologies
9