Publicidad
Idiomas disponibles
Idiomas disponibles
Page 6
ENGLISH
Section 2. General Description
2.1
Introduction
Jandy
Variable Speed Pumps can be run from 600 RPM to 3450 RPM. This allows you to select the most appropriate
®
speed for your application. Pumps in this manual are compatible with all Jandy controllers and Zodiac
systems. The pump is driven by a variable speed ECM (Electronically Commutated Motor) directly attached to the
pump impeller. The motor spins the impeller which forces water to flow through the pump. As the speed of the motor
is varied, the flow through the pump is also varied. The adjustable flow rate allows for optimization of flow during
the varying pump cycle requirements. As a result, the energy efficiency of the pump is maximized resulting in cost
savings to the pool owner while also helping to save the environment.
This manual contains information for the proper installation, operation, and maintenance of pumps listed in this
manual. Procedures in this manual must be followed exactly. To obtain additional copies of this manual, visit
Jandy.com.
2.2
Product Dimensions
NOTE
When installing a pump, leave a minimum of two (2) feet (30 cm) of clearance above the pump for removal of
the strainer basket, working in the wiring compartment, and for opening a closing the lid on the pump controller.
A
B
Bolt Holes,
Center to Center
A
MODEL No.
Dims.
VSFHP185DV2A(S)
10"
VSFHP270DV2A(S)
10"
VSPHP270DV2A(S)
9 1/8"
VSSHP220DV2A(S)
11 5/8"
VSSHP270DV2A(S)
11 5/8"
Figure 1.
Variable-Speed Pump Dimensions
Jandy
Variable-Speed Pumps
®
D
C
Front Edge of Union
to Center of Bolt Holes
B
C
Dims.
Dims.
6 1/2"
7 3/4"
6 1/2"
7 3/4"
9"
8 7/8"
9"
10 3/8"
9"
10 3/8"
|
Installation & Operation Manual
E
F
G
D
E
Dims.
Dims.
12 3/4"
24 1/2"
12 3/4"
24 1/2"
14 1/8"
27 5/8"
15 1/4"
30 1/8"
15 1/4"
30 1/8"
automation
®
F
G
Dims.
Dims.
9 1/2"
9 1/8"
9 1/2"
9 1/8"
11 5/8"
9 1/16"
14"
11 5/8"
14"
11 5/8"
H
H
Dims.
14 1/8"
14 1/8"
15"
15"
15"
Publicidad
