MUCAR CS2 Manual Del Usuario página 12

process. Vehicle DTC are for reference only, and parts cannot be replaced directly based on the given
DTC definition. Each DTC has a set of test procedures. The maintenance technician must strictly
conform to the operation instructions and procedures described in the car maintenance manual to
confirm the root cause of the breakdown.
As shown below, click "Read Fault Code", and then the screen will display diagnostic
results.
Screen buttons:
Freeze frame: If this button is highlighted, it means there is freeze frame information.
The freeze frame serves to record some specific data streams at the moment when the
car breaks down. The number is for verification.
Report: Save the current diagnosis result as a diagnosis report. The diagnostic report
is saved in the File module and can be sent to designated e-mail boxes.
Tips: After the report is produced, the technician can take a real-time photo of the vehicle and save it as
a vehicle maintenance file.
C. Clear Fault Code
This function serves to clear the DTC of the ECU memory of the tested system.
Click "Clear Fault Code", and then the system can automatically delete the existing DTC
and pop up the dialogue box saying "DTC successfully cleared".
Note: For general vehicles, please strictly follow the normal sequence: read the DTC , clear it, have a
test run, read the DTC again for verification, repair the vehicle, clear the DTC, and try again to confirm
that the DTC no longer appear.
D. Read Data Stream
This function is majorly used to read and display real-time data and parameters of the car
15
www.mucarco.com
www.mucarco.com
ECU. Through observing these data streams, maintenance technicians can understand
the vehicle's overall performance and offer maintenance suggestions.
Screen buttons:
want to choose all the data streams, click this button.
display the dynamic data of selected data streams.
Screen buttons:
Report: Click the button to save the number of current data streams.
Select all: If you want to check some data stream, tick the box before its name. If you
Deselect: Click this button to deselect all checked data streams.
OK: Confirm current operations. Click "OK" after selection, and then the system will
(Graph): Click it and the data streams are displayed in dynamic wave patterns.
16