MUCAR CS2 Manual Del Usuario página 13

Record: It's used to record diagnosis data so that users can replay and check it. If
you want to stop the reading, click "stop" (the white box before the progress bar). The
diagnostic record is saved in the File module. It can be sent to designated e-mail boxes
and reviewed for troubleshooting and analysis.
If the 1 / X appears, it means that the data stream options haven't fully displayed. Swipe
the screen from bottom to top to display the remaining options. With 3 display modes
available, you can browse it with suitable ways:
• Figure: Displays parameters with wave patterns.
• Value: The default display mode shows parameters with numbers and lists.
Note: If the value of the data stream is not within the standard value range, the data stream will be
displayed in red.
• Combine: The graphs are presented together for users to make comparisons.
Note:different data flow options are marked in different colors.
How to check one wave pattern?
Click .
On the display page of wave patterns.
Choose the data stream options to be checked (Note: Only a maximum of 4 data streams
can be displayed).
If you want to remove the wave pattern of some data stream, just deselect it.
How to check several wave patterns together?
Click [Combine] button and then the system will display the parameters of the selected
data streams with wave patterns.
17
www.mucarco.com
www.mucarco.com
Diagnosis History
Usually, every time a car is diagnosed, the system will record each step. This function
helps users quickly enter a previously tested vehicle and continue its testing without
starting anew. Click "History" and all previous records will be displayed on the screen
chronologically.
Screen buttons:
Select all: click it and select all diagnosis records.
Delete: click the button to delete some checked diagnosis record.
Unselect: click it to deselect all checked diagnosis records.
Click some diagnosis record to check details about vehicle information and DTC.
Click "Quick access" to test other systems.
18