Publicidad
Idiomas disponibles
Idiomas disponibles
dry. Do not put the battery in the
battery charger if it is dirty or wet.
1. Connect the battery charger to a power outlet.
The charging LED flashes red 1 time and
green 1 time.
CAUTION:
battery charger to a power outlet
with the voltage and frequency
specified on the rating plate.
2. Connect the battery to the battery charger.
The charging LED comes on.
3. Remove the battery from the battery charger
when it is fully charged. Push the battery
indicator button for battery status. When all
the LED indicators come on, the battery is
fully charged.
4. Pull the power plug to disconnect the battery
charger from the power outlet. Do not pull the
power cord.
To connect the battery to the product
WARNING:
original batteries in the product.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it
is not installed correctly.
3. Press the lower part of the battery and
push it in as far as it will go into the
battery compartment. The battery will lock into
position when you hear a click.
12
Only connect the
Only use Husqvarna
4. Make sure that the latches snap in place
correctly.
To start the product
1. Push and hold the power button (A) until the
green LED light (B) comes on.
B
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the power button until the
green LED light comes off.
3. Remove the battery from the product. Push
the two release buttons and pull out the
battery.
A
1776 - 004 - 11.01.2023
Publicidad
