Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. The plug must only
be used with an appropriate wall
socket,
installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
electrician to install an electrical socket
that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig. A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not use
an adaptor with this appliance.
Always
observe
recommendations
electrical appliances:
1
Make sure that the mains supply
voltage matches that of the machine
correctly
and
the
following
when
using
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match the
pins for plug on the machine.
2
To reduce the risk of electrical shock,
first put the switch to the "0" position
and then unplug it from the wall socket.
Always unplug the unit immediately
after use and before proceeding to
clean it.
3
Make sure that the treadmill is
switched off and unplugged before
beginning any type of maintenance or
assembly work on it.
4
Do not unplug the treadmill by
tugging on the mains cable.
5
Do not use the machine if the mains
cable becomes damaged or worn.
6
Keep the mains cable away from hot
surfaces.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device will be automatically
triggered if the unit is subjected to
abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the casing,
to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should
the
repeatedly then the most probable
causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used,
- Belt is too tight.
18
circuit
breaker
trip
Publicidad
