Publicidad
Idiomas disponibles
Idiomas disponibles
> Toavoid electrical shock w hchcan
causeseverepersonal injuryor
death, disconnect power tofreezer
before d efrosting.
> Waterdamage dueto improper
defrosting or drainage m aycause
mold/mildew
growth.
Toavoid property darnagel donotuse
sharp orpointed
i nstruments to scrape
frost from shelves or interior surfaces.
Manual defrost freezers need to be
defrosted when frost has accumulated to
approximately Y4"(6 mm) of thickness.
Complete defrosting and cleaning should
be done at least once a year. In high
humidity areas, more frequent defrosting
and cleaning may be necessary. The
upper section of the freezer will generally
have more frost accumulation than the
lower. Frost should not be scraped or
pulled out of the freezer, as damage may
result.
Amana Free-O-FrostTm (select models)
freezers do not require defrosting.
MANUAL DEFROST
FREEZERS
(SELECT MODELS)
1. Transfer food to another freezer or a
well insulated cooler.
2. Disconnect power to freezer.
3. Remove the toe grille (select models)
by pulling it forward.
4. Reach underneath the freezer and pull
out the defrost drain tube. Place the
tube in a shallow pan or in a nearby
floor drain.
5. Remove defrost drain plug (select
models) from the bottom front of the
freezer liner so the defrost water will
flow into the drain tube.
• Empty pan as often as necessary
during the defrost.
NOTE: Some models do not have a
drain plug and water collecting from the
defrost will have to be removed manually.
6. Tospeed defrosting, pans of hot water
may be placed on shelves in the
freezer.
7,
• Do not bend, scrape or try to
move shelves. Shelves are part of
the sealed cooling system and
can be damaged,
Once defrosted, clean the freezer
according to guidelines in Hints and
Care.
To avoid electrical shock which can
Cause severe personal injury or death,
disconnect power to freezer before
repladng light bulb. After replacing
light bulb, connect power.
To avoid personal injury or property
damage, observe the following:
>Allow
light bulb to cooi.
>Wear
gloves when replacing light
bulb.
1. Disconnect freezer.
2. Pinch tabs on light cover and pull
straight down.
3. Remove light bulb.
4. Replace bulb.
5. Replace protective cover.
6. Reconnect power supply.
NOTE: Manual defrost freezers use a
15-watt appliance bulb. Automatic de-
frost freezers use a 40-watt appliance
bulb.
8. Clean defrost drain using a bottle
brush. Flush the drain with clear water
before replacing the drain tube and
drain plug.
• Drain
plug
must
be
properly
installed and tightly sealed for
efficient operation of the freezer.
9. Restore power to the freezer.
9
Publicidad
