Publicidad
Idiomas disponibles
Idiomas disponibles
02 General Use
Light On/Off
•
Use this control to switch the light on independently of the fan motor, it will be lit red in this mode.
•
When the fan is in use, and the light is off, the icon will be lit white in this mode, but will turn red if the
light is then switched on.
Fan On/Off and Speed Reduction
•
Press this icon once to turn on the fan motor at speed 1. All icons will be white and the light icon will be
red if already in use.
•
If the motor is on speed 1, pressing and holding this icon for two seconds will turn off the fan motor. As
above, the light control is independent of this operation.
•
If the motor is higher than speed 1, this will reduce the fan speed with each press of the icon.
LED Display
•
Shows the extraction mode during set up and the motor speeds from 1-5, and P for Boost.
Boost Function and Speed Increase
•
Press this icon once to turn on the fan motor at full power, and P will flash in the display.
•
If the motor is already on speed 1-5, each press of this icon will increase the fan speed accordingly.
•
If you press and hold the icon for two seconds, the fan speed will increase to full power and P will flash
in the display.
Setting the Timer
•
When the fan motor is on and the Timer icon
display will start to flash and continue until the timer cycle has completed.
•
The chosen speed level will remain in use for five minutes before dropping down to the next lowest
speed. This speed will remain in operation for two minutes before dropping down again. This will be
repeated every two minutes unless the speed is already at level 1 and then the fan will turn off. If the
light is already on, this will also be turned off.
•
Pressing the Speed Reduction icon
restart the countdown process again with a five minute cycle.
•
If the Timer icon
icon will revert to white and the current fan speed will remain on indefinitely.
•
The maximum timer program cycle is 15 minutes: 5 minutes on P and then 2 minutes each on speed 5
down to speed 1.
03 Controlling the cooker hood remotely
IMPORTANT: THIS SECTION IS ONLY APPLICABLE IF YOU HAVE ALSO
PURCHASED A COMPATIBLE HOB WITH RADIO FREQUENCY (RF)
CAPABILITY. CONTACT THE CUSTOMER HELPLINE AT THE END OF THIS
MANUAL FOR COMPATIBLE MODELS.
The process for connecting the hood to the hob happens in three stages:
A) Configure the hob to transmit a radio frequency signal.
B) Configure the hood to receive this signal.
C) Lock the connectivity between the two appliances and complete the pairing process.
IMPORTANT: COMPLETE THIS SET UP WITHIN TWO MINUTES OF TURNING
ON THE RESIDUAL CURRENT DEVICE (RCD).
5059340446189_MNL_IN_V03.indb 67
5059340446189_MNL_IN_V03.indb 67
or Speed Increase icon
is pressed again during a current timer program, the cycle will be cancelled, the
is pressed, it will be red and the current speed in the
during a current timer program will
67
8/6/2022 3:27 PM
8/6/2022 3:27 PM
Publicidad
