Kingfisher CLCH60LKSS Manual De Instrucciones página 8

carried out in accordance
with the instructions. Refer to
the Care and Maintenance
sections carefully for details
on how to clean and replace
the aluminium and carbon
filters (if fitted).
• The LED lamps in this
appliance are not replaceable
by the consumer. If a lamp
fails, please contact the
customer helpline at the end
of Care & maintenance to
arrange an engineer visit.
• Do not use a steam cleaner
for care and maintenance.
• The appliance is not intended
to be operated by means of
an external timer or separate
remote control system.
• There shall be adequate
ventilation of the room when
the hood is used at the same
time as appliances burning
gas or other fuels. Ensure
that the negative pressure of
the installation site does not
exceed 4 Pa (0.04 mbar) to
ensure combustion fumes are
not drawn back into the room.
• Do not use the hood if it
shows signs of damage
or imperfection. Contact
customer services for
assistance.
5059340446189_MNL_IN_V03.indb 7 5059340446189_MNL_IN_V03.indb 7
• The manufacturer declines all
liability for personal or material
damage as a result of misuse
or incorrect installation of this
appliance.
• The appliance is for domestic
use only as an extractor hood.
Electrical Installation
All installation must be carried out by a competent
person or qualified electrician. Before connecting
the mains supply ensure that the mains voltage
corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the
mains using an omnipolar circuit breaker with a
minimum opening of 3 mm between the contacts.
The installer must ensure that the correct electrical
connection has been made and that it complies with
the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for
damage. If the supply cord is damaged, it must be
replaced by a special cord or assembly available
from the manufacturer or its service agent.
IMPOTRANT: THIS IS A CLASS
I APPLIANCE AND MUST BE
EARTHED
This appliance is supplied with a 3 core mains cable
coloured as follows:
Brown - L or Live
Blue - N or Neutral
Green and Yellow = E or Earth
This appliance should be connected directly to
the consumer unit with a 3 Amp Residual Current
Device (RCD) protecting its circuit.
To avoid the risks that are always present when you
use an electrical appliance it is important that this
appliance is installed correctly and that you read
the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for
future reference and pass it on to any future owners.
After unpacking the appliance please check that it is
not damaged. If in doubt, do not use the appliance
but contact Customer Services.
7
8/6/2022 3:27 PM 8/6/2022 3:27 PM