Vermeiren LiNX 200 Manual De Instrucciones página 12

EN
NL
Unspecified
4.7 Changing drive function
The wheelchair's speed functions can be operated using the drive select button.
There are three available drive functions.

Press the top of the button to select the next drive function. Press the bottom
of the button to select the previous drive function.
The selected drive function is indicated on the drive function indicator, to the right-hand side of
the drive select button. The indicator has three LED's, one for each available drive function. When
drive function 1 is selected, only the bottom indicator will be lit. For drive function 3, all LED's will
be lit.
The maximum driving speed by maximal deflection of the joystick depends on the selected drive
submenu (1, 2 or 3) and the manual speed setting in this submenu.
4.7.1 Adjusting the driving speed
Slow
4.7.2 Limited driving speed
For your safety, the driving speed of your wheelchair will be automatically reduced when certain
body position alterations have been made. The drive of the wheelchair is then limited to the lowest
speed setting, or even becomes completely blocked.
3
Driving and speed limitations occur when:
 the lift has been adjusted to a higher position. Only speed setting 1 is available.
 the backrest inclination exceeds a certain angle (see figure 7):
Fast
In each of the three drive functions, the speed can be adjusted in 10
discrete steps between lowest (left) and highest (right) speed, using
the speed switch. This rotary switch is located around the ON/OFF
button. As a visual reminder, a speed symbol is positioned above the
speed switch to indicate the low and high positions.
Speed switch
1
2
Backrest inclination
None
Drive function button
10
LiNX 200
2023-03
Operating console functions
Driving inhibition indicator