S&P CAD HE 450 H BASIC Manual De Instrucciones página 21

1. GENERAL INFORMATION
1.1 Introduction
This product was manufactured according to rigorous technical safety rules in
compliance with DC standards. The DC declaration and the manual can be
downloaded from the Internet.
Before installing and using this product, carefully read these instructions, which contain
important indications to ensure your safety and that of the users during the installation,
commissioning and servicing of this product.
Once the installation is terminated, store the manual on a place where it is accessible.
The installation of this product (implementation, connections, commissioning, and
maintenance) and all other interventions must be performed by a professional, applying
the recognized rules of good practice, standards and safety regulations in force.
It must conform to the prescriptions related to Electromagnetic Compatibility (EMC) and
the Low Voltage Directive (LVD).
S&P shall not be held responsible for possible injuries and/or damages caused by the
non-compliance with safety instructions or following a modification of the product.
The CAD HE 450 units are designed for dual flow air ventilation and air treatment
applications in public and private buildings:
 Indoor installation
 Minimum recommended ambient temperature where the unit is installed >10ºC
 Working temperature: -25°C / +40°C.
 Relative humidity: max 95% non-condensing.
 Atmosphere not potentially explosive.
 Atmosphere with low salt content, without corrosive chemical agents.
Acceptance – Storage
1.2
In case of missing, non-conforming, or totally or partially damaged delivered products,
the Purchaser must make written reservation on the transporter's receipt and confirm
them within seventy-two (72) hours by sending a recommended letter to the
transporter, as well as a copy to S&P. Acceptance of the equipment without any
reservation will deprive the purchaser of any subsequent recourse against us.
The product must be stored in an area protected from bad weather, shocks and stains
due to splashing or splattering of any kind during its transport from the supplier to the
end customer and onto the worksite before installation.
21