cinetto PS66 Instrucciones De Ensamblaje página 133

Check the levelling of the doors. If the structure of the door does not guarantee perfect levelling, the installation of a tensioner to straighten the
doors is recommended.
Check that there are no physical obstacles in the path of the door. Check that the system's wiring is not in the path of the door or of the door to
movement bar connection.
Finally, unplug and re-plug the control unit power supply jack and press the 'SET/RESET' button on the control unit for three seconds.
6.4 The supplied remote control does not work
Check that pairing has been successfully completed (see Section 3.4).
Check that you are using the buttons that are active for the chosen configuration. See the specific instructions of the sliding arrangement
combined with the 'B-Moved' system.
If pairing of the remote control still does not work, replace its internal battery (type CR2032 3V), by removing the screw on the back of the remote
control, and then repeat the pairing process indicated in Section 3.4.
6.5 The doors collide during movement
The system's logic should prevent collisions between the doors. In the event that any collisions occurs:
• Check that the wiring complies with the associated sliding system installation instructions;
• Unplug the power supply jack from the control unit, reposition according to instructions, re-plug the jack in the control unit and wait at least
10 seconds;
• Activate the track limit self-learning procedure by pressing the 'SET / RESET' button for 3 seconds.
6.6 The appliance (e.g. interior light) connected to the switch does not work according to expectations
Check the appliance is connected properly, as indicated in Section 3.5.
Remember that the switch does not supply an output voltage, and acts as a simple switch. Connect one of the 2 poles of the power supply to
the switch to have the device controlled by the control unit.
Check that the device is compatible with a maximum power supply of 48V and absorbs a maximum current of 2.1A.
7. Serial number
The reference serial number of the B-moved system
can be found on the bottom of the control unit.
RAEE IT19010000011107
The symbol on the product or on packaging indicates that this product may not be treated as household waste. Instead it shall be
handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could
otherwise be otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling
of this product, please contact your local city office, you household waste disposal service or the shop where you purchased the
product.
KIT B–MOVED
XXXXXXXXXX
PS66 & B-moved.
KIT B–MOVED
XXXXXXXXXX
Assembly Instructions Cinetto 133