EINHELL FREELEXO SMART Manual De Instrucciones página 52

Fault messages of the robot lawn mower in the LCD display (50)
Fault
Motor fault /
motor overcurrent
Breakdown
Troubleshooting
Fault
The robot lawn mo-
wer comes to a stop
in the mowing area.
The robot lawn
mower cannot be
switched on:
The robot lawn
mower cannot move
into the charging
station.
The robot lawn mo-
wer stops or travels
out of control when
near perimeter is-
lands.
Anl_FREELEXO_SMART_SPK13.indb 52 Anl_FREELEXO_SMART_SPK13.indb 52
GB
Possible cause
- The robot lawn mower has
come to a stop because of
overcurrent in the motor or
because of a motor fault
- The robot lawn mower was
stopped due to an operating
error
Possible cause
- Battery voltage too low
- Fault in the power circuit or
the electronic components
- The charging station (19) is
not installed correctly.
- The perimeter wire (18) has
not been installed correctly
around the perimeter islands.
- 52 -
Remedy
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
- Check the height of the grass in the
mowing area and, if necessary, mow the
grass to below 60 mm using a conventio-
nal lawn mower.
- Increase the cutting height. Always start
with a higher cutting height and reduce it
in small steps until you reach the desired
height.
- Inspect the blade plates (11) and wheels
for dirt and give these parts a thorough
clean.
- Check the rear wheels and the blade plate
(11) for blockages. If you are unable to
remove the blockages, contact the res-
ponsible customer service center.
Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to restart
the robot lawn mower.
Remedy
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
- Make sure that the LED indicator (21) on
the charging station (19) is lit up green.
- Make sure that the perimeter wires (18)
are connected at the charging station (19)
and that the front perimeter wire (18) is
laid in the middle underneath the charging
station (19).
- Make sure that the charging station (19) is
positioned correctly.
- Adjust the position of the perimeter wire
(18).
- Make sure that the perimeter wire (18)
does not cross over itself
10.10.2022 12:44:23 10.10.2022 12:44:23