GYS POT COMBI ARCPULL Manual De Instrucciones página 29

Operating manual
Power source GYSPOT COMBI ARCPULL (FIG-I)
1- Alu Keypad
2- Switch (On/Off/On)
3- Steel Keypad
4- Ground cable Steel
5- Gun trigger connector Steel
6- Texas/dinse for gun with trigger Steel
7- Texas/dinse for triggerless gun Steel
Automatic gun GYSPOT ARCPULL 200 - Aluminium function (FIG-I)
1- Trigger
2- Locking ring for electrode holder
3- Locking knob for rods
4- Connector for gun control cable
5- Positive Texas/dinse
ALU HUMAN-MACHINE INTERFACE (HMI) (FIG-II)
1- Menu/Enter button
2- Back/return button
3- G+ button
4- G- button
STEEL HUMAN-MACHINE INTERFACE (HMI) (FIG-II)
1- Tool display
2- Power level display
3- Spot time display
4- Manual ignititon indicator light
5- Automatic ignition indicator light
6- Ignition type selection button
7- Thermal fault indicator light
POWER SUPPLY AND START-UP
• This product is supplied with a 16 A CEE7/7 plug and must be connected to an electric installation
which is three-wire single-phase 230V (50-60Hz) with an earthed neutral. Check that the power supply and its pro-
tection (fuse and/or circuit breaker) are compatible with the current required to run the machine. This equipment is
designed to operate on an electrical installation equipped with a 16A curve C, D or K circuit breaker.
The effective absorbed current (I1eff) for aluminium and the permanent absorbed current (I1p or ILp) for steel is
shown on the device for the maximum operating settings.
Aluminium function
The left-hand side of the product is the drawn-arc function, it is used for welding inserts: primarily pull rings on alumi-
nium based materials, but also studs and insulation nails on aluminium or steel based materials. It has a Synergic mode
and a Manual mode.
• To switch the unit on, turn the on/off switch in the centre of the product to the left "|".
• The device will enter protection mode if the power supply voltage is over 265 V AC. (If this is the case, the machine
displays POWER DEFAULT). Normal functioning will resume once the power supply is under 265V.
• When it starts up, the product always runs in synergic mode. Changing the mode (Manual or Synergic) is done via the
Main Menu.
Delivered with the following aluminium accessories:
Gun
Original manual
8- Texas/dinse for Alu gun cable (-)
9- Texas/dinse for Alu gun cable (+)
10- Sub-base for Alu gun control cable connector
11- Gas outlet for gun cable (Alu)
12- Mains cable
13- Gas inlet connected to the cylinder (15 l/min) (G1/4 D6)
14- USB connector for Alu software updates
Ring holder
6- Negative Texas/dinse
7- Gas inlet
8- On LED (green)
9- Contact LED (blue)
10- Fault LED (red)
5- D+ button
6- D- button
7- Screen/display
8- Mode selection button (Manual/Synergic)
9- Spot-weld time selection buttons (+/-)
10- MANUAL mode indicator light
11- Power level selection buttons (+/-)
12- SYNERGIC mode indicator light
13- Tool selection buttons (+/-)
Accessories and
Pulling rod
consumables box
GYSPOT COMBI ARCPULL
29