GYS POT COMBI ARCPULL Manual De Instrucciones página 31

Operating manual
The binding: The gun plunges the insert into the molten weld pool.
Note : In the case of steel, the thickness of the supporting sheet must not be less than ¼ of the diameter of the insert,
and ½ of the diameter in the case of aluminium.
DRAWN ARC WELDING
Check the polarity of the gun's texas/dinse:
Insert to be welded
Alu pulling ring
Stud, aluminium insulation nail
Steel pulling ring
Stud, steel insulation nail, etc
Every 30 pull ring welds, the message "Check stems"
appears on the display. Check the end of the ground
rods If they show signs of
welding, lightly sand them with abrasive paper to
restore their electrical contact.
Press to confirm and reset the
counter.
WELDING IN MANUAL MODE
In Synergic Mode the height of the arc, the time and current for the different phases are selected automatically by the
machine. A synergy is therefore determined by the type of part to be welded, its material, its gas protection, its size,
and the supporting plate.
The gas type to be used is shown on the display. In case of incorrect polarity on the gun, a message appears on the
display and the fault LED (red), on the gun, flashes.
The different welding parameters are defined for the attachments that GYS sell.
These synergies remain applicable for inserts up to 35mm, as long as they are of the same type and material as
those sold by GYS (according to ISO 13918).
The synergies of aluminium inserts (excluding pull rings), were established on support plates that had been preheated
to a temperature of 50-60°C.
It is advisable to carry out a few test welds on a suitable support plate beforehand, to ensure that the weld will hold.
On the main Mode screen, Synergies are displayed:
1 — The material of the insert: AlMg, Fe, FeCu, etc.
2 — The type of weld pool protection: No Gas, the type of gas recommended
3 — The pictogram of the part to be welded
4 — The thickness of the sheet metal to which the part will be welded
5 — A message field specifying the status of the product
Original manual
1. Mount the ring holder
2. Strip off all paint from the area where the weld is to be executed.
3. Select the correct synergy to suit the welding of the ring.
4. Connect the negative texas plug from the gun to the unit (no earth clamp is
used).
5. In the case of manual operation; set the digital "Flex" spring to OFF
6. Insert a ring into the ring holder.
7. Unlock the ground rods with the knob.
8. Position the gun on the workpiece and bring the ring into contact with it. As
soon as the gun makes a "beep" or that the LED contact (blue) is switched on,
lock the ground rods with the knob.
9. Press the trigger
10. Once the weld is complete, unlock the knob to release the pins and lift the
gun to disengage the ring.
Positive cable connection
(red mark)
Negative dinse connector (-)
Positive dinse connector (+)
Positive dinse connector (+)
Positive dinse connector (+)
Negative dinse cable
Positive dinse connector (+)
Negative dinse connector (-)
Negative dinse connector (-)
Negative dinse connector (-)
GYSPOT COMBI ARCPULL
Usage
Recommended
Recommended
Possible
Possible
31