GYS POT COMBI ARCPULL Manual De Instrucciones página 37

Operating manual
Adjust the gun rods so that they are 120mm in
length (measurement between the end of the rods
and the edge of the flanges).
Tighten the two rod clamping screws.
Replace the cover on the front of the gun and tigh-
ten the two retaining screws.
USE OF THE PULL RING ATTACHMENT
Slightly unscrew the knurled nut on the drive shaft of the
gun.
Position the ring holder until it stops and then tighten the
knurled nut.
Position the pull ring in the ring holder until it stops.
INSTALLATION OF A STUD HOLDER
• Position and thread the stud holder into the gun barrel.
• Position and lightly thread the gas protection nozzle onto
the stud holder.
• Position the adjusted stud holder in the protective nozzle.
• Screw on the protective nozzle.
• Reposition and screw the pad and the cover onto the
ground rods.
Note: When screwing the various components together, the
gun barrel must always be tightened with a spanner.
Original manual
L
Protective nozzle
Stud holder
Stud holder support
Pad and cover
GYSPOT COMBI ARCPULL
Gun barrel
37