Sauder Lateral File 107302 Instrucciones De Montaje página 12

Step 8
IMPORTANT: The EXTENSION RAILS may slide out when
å
turning the unit over in this step. Be careful not to bend
the RAILS or scratch the fl oor.
Carefully turn your unit over onto its front edges. Lay the
å
UPPER BACK (D) over your unit.
NOTE: Be sure the angled corners are in the locations
å
shown. Follow the diagram.
ATTACHING THE UPPER BACK:
å
1st: Turn three 7/16" LARGE HEAD SCREWS (JJ) into the
row of holes along the bottom edge of the UPPER BACK (D)
and into pre-drilled holes in the LOWER BACK (E).
2nd: Be sure there is an equal amount of margin along the
å
three remaining edges of the UPPER BACK.
3rd: Turn a 7/16" LARGE HEAD SCREW (JJ) through the
å
remaining holes in the UPPER BACK and into the edges
of the ENDS and TOP.
NOTE: There are no pre-drilled holes in the edges of the
å
ENDS and TOP. Be sure to use the 7/16" LARGE HEAD
SCREWS (JJ).
Carefully stand your unit upright.
å
Page 12
D
E
107302
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
BROWN 7/16" LARGE HEAD SCREW
(10 used in this step)
Angled edge
B
www.sauder.com/services
JJ