Sauder Lateral File 107302 Instrucciones De Montaje página 16

Step12
Both diagrams show a see-through view of the TOP (C).
å
This is done to show the positioning of the LOCK (DD).
Fasten the LOCK (DD) to the RIGHT END (A) in the exact
å
order shown in the upper diagram. It is important to make
sure the CAM points exactly as shown. Meanwhile, the
key must turn counter-clockwise 1/4 turn to lock properly.
The CAM should swing upward when locked.
NOTE: If the key will not turn counter-clockwise, turn it
å
clockwise and fasten the CAM exactly as shown.
NOTE: When the DRAWERS are locked, the CAM should
å
be positioned inside the LOCK ACTUATOR (CC) as shown
in the lower diagram.
CC
This is the position the CAM
will be in when it is locked.
Page 16
The end of the CAM must be
closer to the RIGHT END than
the other end of the CAM.
A
107302
SCREW
CAM
The prongs must press into the
RIGHT END as you tighten the
NUT with an adjustable wrench.
Just breathe.
It's going to be ok.
C
NUT
WASHER
DD
Turn the KEY
counter-clockwise
A
to lock it.
www.sauder.com/services