Lavor NEXT EVO Manual De Instrucciones página 34

7 - OPERATING INFORMATIONS
7.1 MACHINE PREPARATION
Before starting to work, wear non-slip shoes,
gloves and any other personal protection device
indicated by the supplier of the detergent used
or considered necessary based on the operating
environment.
Do the following checks before starting to work.
Refer to the relative sections for a detailed de-
scription of these steps:
Check the battery charge level and charge the bat-
tery if necessary (see 7.2).
assemble the brush or pad driver (with the abrasive
pad) that are suitable for the surface and work
involved (see 7.3).
Assemble the squeegee, check that it is solidly at-
tached and connected to the suction hose and that
the drying blades are not too worn (see 7.5).
Fill the detergent solution tank with a mix of clean
water and non-foaming detergent in an adequate
concentration through the anterior hole. Leave 2
cm between the mouth of the plug and the level of
the liquid (see 7.9).
To avoid risks, become familiar with the ma-
chine movements, carrying out test runs on a
large surface without obstacles.
To obtain the best results in terms of cleaning and
equipment service life, you should do the following
simple but important operations:
- Identify the work area, moving all possible ob-
stacles out of the way; if the surface is very
extensive, work in contiguous and parallel rec-
tangular areas.
- Choose a straight work trajectory and begin
working from the farthest area to avoid passing
over areas that have already been cleaned.
7.1.1 LANGUAGE CONFIGURATION
Photo 6. Keep A and B pressed and turn the power
on key. When " calibration" is displayed press F too.
Release all the buttons. Press C+ or C- to select
" language" and press F to confirm.
In the main menu select " exit" and press F to con-
firm.
7.2 BATTERY CHARGING
Collegare il cavo di prolunga al cavo di alimenta-
Connect the patch cord to the power cable of the
battery charger ( Photo 15 - A ) and to the mains
power.
When switching on, the battery charger CBHD1 will
check the battery voltage and decide whether to
start the charging process. If the battery is not con-
nected to the battery charger, the red LED will flash
( Photo 14 - A ). If the result of the test is posi-
tive after 1 second the charging of the battery can
start, with the red LED on.
The progress of the charging process is shown by
three LED' s: red, yellow and green, as in the whole
range of the battery chargers.
The green LED ( Photo 14 - C ) shows the end of
the charging. Disconnect the battery charger from
the mains power.
For further information refer to the use and sa-
fety manual of the battery charger provided by
the manufacturer.
If the machine is equipped with Pb-Acid batteries,
charge only in a well-ventilated area, remove the
recovery tank and open the battery plugs.
Follow the steps indicated in the battery manu-
facturer' s operating and safety manual (see the
battery maintenance section).
Use an hydrometer to check the element liquid in-
tensity on a regular basis: if one or more elements
are discharged and the others fully charged, the
battery has been damaged and should be replaced
or repaired (refer to the battery service manual).
A
LED
ROSSO
Photo 14
Photo 15
A) On-board battery charger
B) Battery charger power supply cable
C) Squeegee lifting/lowering lever
34
B C
LED LED
GIALLO VERDE