Lavor NEXT EVO Manual De Instrucciones página 37

7.8 FILLING, CHECK OF THE FILLING LE-
VEL AND DRAINING THE SOLUTION TANK
The temperature of the water or the deter-
gent should never exceed 50°C
At every filling of the solution tank (Photo 1 - D),
always remember to empty the recovery tank
(Photo 3 - C) (see 7.10).
7.8.1FILLING OF THE SOLUTION WATER
TANK
IThe filling of the solution water tank should
NOT be done with the machine in the raised
position.
- Pour into the tank the required quantity of the
chemical product, considering the percentage
indicated by the supplier, with reference to the
full tank capacity listed on the product sheet.
Use only those products suitable for the floor
and the dirt to be removed.
- Pour water in the filling opening placed in the
front of the machine ( Photo 22 - A ).
Leave 2 cm between the filling opening and the
liquid level. Do not fill beyond this point!
B
Photo 22
A) Solution tank filling opening with filter
B) Closing cap
The machine have been designed for the
use with non-foaming and biodegradable
detergents made specifically for scrubber-
driers.
The use of other chemical products (such as so-
dium hypochlorite, oxidizers, solvents or hydro-
carbons) may damage or destroy the machine.
- Follow the safety regulations specified in the re-
lative section and indicated on the detergent
container.
- Contact the machine manufacturer to obtain a
complete list of available and suitable deter-
gents.
Always use non-foaming and biodegrada-
A
ble detergents
- Do not leave the water hose unattended and in-
sert it completely into the tank: the hose might
move and get sensitive parts of the machine
wet.
- Close the tank with its plug.
7.8.2 DISPLAY OF THE FILLING LEVEL OF
THE SOLUTION WATER TANK
The filling level of the solution water tank can be
viewed through the transparent hose at the rear of
the machine (Photo 23 - A).
B
A
Photo 23
A) Drain hose of the solution tank with
level display
B) Plug of the drain hose
7.8.3 DRAINING OF THE SOLUTION WATER
TANK
The emptying of the solution water tank can be
made through the transparent hose on the back of
the machine (Photo 23 - A).
- Disconnect the hose from its holder and place it
next to a container or a sewer drain.
- Remove the cap of the hose (Photo 23 - B) and
wait for the complete emptying of the tank.
- After the draining, close the hose with the cap
and place it in its slot.
37