FUXTEC FX-MS125 Manual De Instrucciones página 58

Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01
To release the new thread, run the engine at full throttle and tap the nylon
cutting head onto the lawn. The threaded head automatically releases
further threads. The blade in the protective shield cuts off the excess thread.
CAUTION: Remove grass deposits regularly to prevent overheating of the
drive axle. Grass deposits occur when fibres of the weed are entangled
around the shaft under the protective shield. This prevents the shaft from
cooling correctly. Remove grass deposits with a screwdriver or similar tool only when the
device is switched off.
When the device is appropriately equipped with a protective shield and nylon cutting
head, your device will trim unsightly weeds and large-diameter tall grass in areas along
fences, walls, land, and around trees.
NOTE: Pay particular attention when trimming on brick or stone walls, etc., where rapid
weed wear will occur.
MORE PRECISE TRIMMING
Swing the trimmer's nylon cutting head horizontally
from side to side. Do not tilt the nylon cutting head
while working. For correct cutting height, trim in a
test area beforehand. Keep nylon cutting head at
the same level for even depth of cut.
TRIMMING AROUND TREES
Trim around logs with a slow approach; the thread
should not collide with the log. Walk around the tree from left to right—approach grass
or weeds with the tip of the thread.
58